Do you have trouble starting your lawnmower in the spring? Before you decide to take your lawnmower for repair, try these simple tips. After graduation, most of the time your lawnmower will fire and run like a champion.
Remove and clean the spark plug
Most of the time simply cleaning the spark plug will solve your suffering lawnmower. To do this, pull the wire until the end of the candle attached. Then remove with a wrench or ratchet / socket, remove theCandela. If the candle is black or wet looking, you probably found the problem, why not start the mower.
With fine sandpaper, sand the top of the candle to bare metal. Be sure to sand around the edges of the piece of metal (TAB), which is located just above the electrode. Ensure that there is a gap between the metal tab and the electrode. If you still have the manual mower and a feeler gauge you can adjust the gap with the specifications.However, if there is a small gap, it is probably sufficient for the candle to work properly.
Make sure the candle is dry and free of dust. Tighten the screws back into the bottle back and connect the cable to the end of the candle. Then try the mower.
Control oil
Make sure that the oil in the mower and at the right time.
Check for fuel
Make sure there is gas in the mower. If you have gas in the oldMowers and not put a fuel stabilizer at the end of the season to replace the gas. If you had the gas tank at the end of last season and drained, then fill the tank at least half full with new gas.
Fuel Line Check
How many of us at the end of the previous season, we mow lawns turn the fuel line. Sure that its position. If you consider all the above and the engine is not fired, then check to see if the fuel is always there, theCarburetor. Temporarily disconnect the fuel line from the carburetor and see if gas pours out. In this case, connect the hose. If not, then check the fuel line. It can be glued or is the fuel filter clogged.
Check the air filter
Make sure the air filter is clean. If it gets dirty and oily then replace it. If only shake dirt and knock some dust. That might solve the problem, but I would still recommend replacing it.
Clean theCarburetor
Turn on the fuel line. Dismantling and cleaning the carburetor is not as bad as you might think. There is usually a nut on the bottom of the carburetor. Remove them and pull out the bottom of the carburetor. Clean the inside of the bottom of the carburetor and then make sure that the float valve moves up and down freely. The float valve is a plastic object about 1.5 "in diameter that hangs down when you remove the lower part ofCarburetor.
Close the bottom of the carburetor and turn on the fuel line again.
Start the mower. If it still does not work after the implementation of all these procedures, then it will take to repair. However, from personal experience, the procedures usually solve the problem.
Sharpen the blade
Finally, it should sharpen the blade. This ensures that you minimize the torque of the engine, while cutting the grass. Not to mention, your lawn willGet an even cut.
Leaf Blowers Vacuums flatware1810 http://buycoffeetable.postblog.net
No comments:
Post a Comment